Toyota Corolla Quiz
Seat belt

Inspection

In this manual: Seat belt
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
14steps
~84min
3/5difficulty
Done 0 of 14
1. Inspect front seat inner belt assy lh
Toyota Corolla. Inspect front seat inner belt assy lh
  1. When fastening the seat belt (buckle switch on).
  2. Inspect the continuity and resistance between the terminals.

Standard:

If the result is not as specified, replace the inner belt.

If the result is not as specified, replace the inner belt.

Toyota Corolla. Inspect front seat inner belt assy lh
  1. When releasing the seat belt (buckle switch off).
  2. Inspect the continuity and resistance between the terminals.

Standard:

If the result is not as specified, replace the inner belt.

If the result is not as specified, replace the inner belt.

2. Inspect front seat inner belt assy rh
Toyota Corolla. Inspect front seat inner belt assy rh
  1. short between connector terminals 1 and 2 for the occupation detection sensor (seat is occupied).
    Toyota Corolla. Inspect front seat inner belt assy rh
  2. When fastening the seat belt (buckle switch is on and seat is occupied).
  3. Inspect the continuity between the terminals of the connector for the warning switch.

Standard:

Toyota Corolla. Inspect front seat inner belt assy rh
  1. When releasing the seat belt (buckle switch is off and seat is occupied).
  2. Inspect the continuity between the terminals of the connector for the warning switch.

Standard:

Toyota Corolla. Inspect front seat inner belt assy rh
  1. Disconnect the occupation detection sensor connector (seat is not occupied).
    Toyota Corolla. Inspect front seat inner belt assy rh
  2. When fastening the seat belt (buckle switch is not on and seat is occupied).
  3. Inspect the continuity between the terminals of the connector for the warning switch.

Standard:

Toyota Corolla. Inspect front seat inner belt assy rh
  1. When releasing the seat belt (buckle switch is not off and seat is occupied).
  2. Inspect the continuity between the terminals of the connector for the warning switch.

Standard:

If the result is not as specified, replace the inner belt.

If the result is not as specified, replace the inner belt.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.