Toyota Corolla Quiz
Lighting

Inspection

In this manual: Lighting
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
12steps
~72min
3/5difficulty
Done 0 of 12
1. Headlamp dimmer switch assy
Toyota Corolla. Headlamp dimmer switch assy
  1. Inspect light control switch continuity.
  2. Measure the resistance according to the value(s) in the table below.

Standard:

  1. Inspect headlight dimmer switch continuity.
  2. Measure the resistance according to the value(s) in the table below.

Standard:

Hint:
Hint

: turn light control switch to the head position when checking ”low beam” and ”hi beam”.
  1. inspect turn signal switch continuity.
  2. Measure the resistance according to the value(s) in the table below.

Standard:

  1. W/ fog light: inspect front fog light switch continuity.
  2. Measure the resistance according to the value(s) in the table below.

Standard:

2. Back up lamp switch assy
2. Back up lamp switch assy
  1. measure the resistance according to the value(s) in the table below.

Standard:

3. Stop lamp switch assy (w/o cruise control)
3. Stop lamp switch assy (w/o cruise control)
  1. measure the resistance according to the value(s) in the table below.

Standard:

4. Stop lamp switch assy (w/ cruise control)
4. Stop lamp switch assy (w/ cruise control)
Toyota Corolla. Stop lamp switch assy
  1. Measure the resistance according to the value(s) in the table below.

Standard:

5. Hazard warning signal switch assy
5. Hazard warning signal switch assy
Toyota Corolla. Hazard warning signal switch assy
  1. Measure the resistance according to the value(s) in the table below.

Standard:

  1. Inspect illumination operation.
  2. Connect the positive (+) lead from the battery to terminal 5 and the negative (–) lead to terminal 4, then check that the illumination comes on.
6. Front door courtesy lamp switch assy
  1. measure the resistance according to the value(s) in the table below.

Standard:

7. Rear door courtesy lamp switch assy
7. Rear door courtesy lamp switch assy
  1. measure the resistance according to the value(s) in the table below.

Standard:

8. Luggage compartment room courtesy lamp switch assy
8. Luggage compartment room courtesy lamp switch assy
  1. measure the resistance according to the value(s) in the table below.

Standard:

9. Map lamp assy (w/o sliding roof)
9. Map lamp assy (w/o sliding roof)
Toyota Corolla. Map lamp assy
  1. Measure the resistance according to the value(s) in the table below.

Standard:

  1. Connect the positive (+) lead from the battery to terminal 1 and the negative (–) lead to terminal 6, then check that the illumination comes on when switch operation is on position.
10. Map lamp assy (w/ sliding roof)
Toyota Corolla. Map lamp assy
  1. Measure the resistance according to the value(s) in the table below.

Standard:

  1. Connect the positive (+) lead from the battery to terminal 1 and the negative (–) lead to terminal 3, then check that the illumination comes on when switch operation is on position.
11. Room lamp assy no.1
Toyota Corolla. Room lamp assy
  1. Connect the positive (+) lead from the battery to terminal 1 and the negative (–) lead to terminal 2, then check that the illumination comes on .
13. Headlamp relay
Toyota Corolla. Headlamp relay
  1. Measure the resistance according to the value(s) in the table below.

Standard:

14. Fog lamp relay
14. Fog lamp relay
Toyota Corolla. Fog lamp relay
  1. Measure the resistance according to the value(s) in the table below.

Standard:

15. Taillamp relay
15. Taillamp relay
Toyota Corolla. Taillamp relay
  1. Measure the resistance according to the value(s) in the table below.

Standard:

16. Headlamp dimmer relay
16. Headlamp dimmer relay
Toyota Corolla. Headlamp dimmer relay
  1. Measure the resistance according to the value(s) in the table below.

Standard:

17. Light control rheostat
17. Light control rheostat
Toyota Corolla. Light control rheostat
  1. Connect the connector to the rheostat and inspect the wire harness side connector from the back side as shown in the table below.

Standard:

  1. Inspect illumination operation.
  2. Connect the positive (+) lead from the battery to terminal 2 and the negative (–) lead to terminal 3, then check that the illumination comes on.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.