Toyota Corolla Quiz
Diagnostics

Inspection procedure

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
2steps
~12min
1/5difficulty
Done 0 of 2
1 Inspect skid control ecu connector(+bs terminal voltage)
Toyota Corolla. Inspect skid control ecu connector
  1. Disconnect the skid control ecu connector.
  2. measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector.

    Voltage: 10 – 14 v

    2 Reconfirm dtc
2 Reconfirm dtc
  1. Check the dtc .

    Ok : normal code

3 Inspect contact condition
3 Inspect contact condition
Toyota Corolla. Inspect contact condition
  1. Inspect the condition of the each connector from engine room r/b to skid control ecu.
Check and replace brake actuator assy
Check and replace brake actuator assy

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.