Diagnostics
Inspection procedure
In this manual: Diagnostics
4steps
~24min
2/5difficulty
Done 0 of 4
1 Check security indicator light


2 Check glass breakage sensor ecu (glass breakage sensor)




3 Check wire harness (tvip ecu glass breakage sensor ecu)




4 Check wire harness (glass breakage sensor ecu body ground)




Check and replace tvip ecu
- Set the system in 30 seconds after filliping the security indicator to check if the alarm is triggered.



- Check the continuity and voltage of the glass breakage sensor ecu, as shown in the illustration and table.
Standard:




- Disconnect the tvip ecu and glass breakage sensor ecu connectors.
- check the continuity and between the connectors on the harness side, as shown in the illustration and table.
Standard:




- Disconnect the glass breakage sensor ecu connector.
- check the continuity between the terminal of the glass breakage sensor ecu connector and the body ground, as shown in the illustration and table.
Standard:



Test yourself
A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?