Toyota Corolla Quiz
Engine hood/door

Luggage door hinge torsion bar rh

In this manual: Engine hood/door
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
6steps
~36min
2/5difficulty
Done 0 of 6
Replacement Hint

:
  • installation is in the reverse order of the removal. But the installation is indicated only when it has a point.
  • In the lh side, work in the same procedure as in the rh side.
  • Since the removal of the torsion bar will cause no tension, operation of opening and closing the door should be carried out holding the door by hand in order to prevent the door from closing without any resistance.
  • Rh side torsion bar is in the upper side and lh side torsion bar is in the lower side, thus the installation should be done in the order of rh to lh, and the removal should be done in the order of lh to rh.
1. Remove luggage door hinge torsion bar rh
Toyota Corolla. Remove luggage door hinge torsion bar rh
  1. Remove the torsion bars from the center bracket.
  2. install sst to the torsion bar on the hinge side.

    Sst 09804–24010

    Toyota Corolla. Remove luggage door hinge torsion bar rh
  3. Push down the sst, and pull the luggage compartment door hinge from the torsion bar.
  4. slowly lift the sst, and remove the torsion bar from the torsion bar bracket with sst.
    Toyota Corolla. Remove luggage door hinge torsion bar rh
  5. Disconnect the torsion bar from the bracket.
  6. employ the same manner described above to the other side.
2. Install luggage door hinge torsion bar rh
  1. when installing the torsion bar, be sure to install it to the clamp securely.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.