Toyota Corolla Quiz
Cooling

On–vehicle inspection

In this manual: Cooling
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
9steps
~54min
2/5difficulty
Done 0 of 9
1. Check cooling fan operation with low temperature (below 83 c (181 f))
  1. Turn the ignition switch on.
  2. check that the cooling fan stops.
Hint

: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan relay and water temperature sensor.
  1. disconnect the water temperature sensor connector.
  2. check that the cooling fan rotates.

    If not, check the fuses, cooling fan relay, ecm and cooling fan, and check for a short circuit between the cooling fan relay and water temperature sensor.

  3. reconnect the water temperature sensor connector.
2. Check cooling fan operation with high temperature (above 93 c (199 f))
  1. start the engine, and raise coolant temperature to above 93 c (199 f).
Hint

: coolant temperature is the detected value by the water temperature sensor on the water outlet.
  1. check that the cooling fan rotates.
Hint

: if not, replace the water temperature sensor.

 3. Inspect cooling fan
  1. disconnect the cooling fan connector.
  2. connect battery and ammeter to the connector.
  3. check that the cooling fan rotates smoothly, and check the reading on the ammeter.

    Standard amperage:
    approx. 8.0 – 12.0 A at 20 c (68 f)

  4. reconnect the cooling fan connector.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.