Toyota Corolla Quiz
Seat

Overhaul

In this manual: Seat
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
16steps
~96min
4/5difficulty
Done 0 of 16
1. Remove bench type rear seat cushion assy
Toyota Corolla. Remove bench type rear seat cushion assy
  1. Disengage the 2 clamps, and then remove the seat cushion.
2. Remove separate type rear seat back assy
  1. lean the seat back forward.
  2. remove the 2 clips.
  3. remove the 2 bolts and seat back lh.
  4. employ the same manner described above to the other side.
3. Remove bench type rear seat cushion cover
  1. remove the hog rings and seat cushion cover.
4. Remove separate type rear seat back cover
  1. remove the hog rings, and then turn up the seat back cover lh.
  2. remove the headrest supports, seat back cover lh and seat back pad lh.
  3. employ the same manner described above to the other side.
5. Install separate type rear seat back cover
  1. install the seat back pad lh to the seat back frame lh.
  2. cover the top of the seat back with the seat back cover lh.
  3. install the headrest supports.
  4. using hog ring pliers, fully install the seat back cover lh with new hog rings.
  5. employ the same manner described above the other side.
6. Install bench type rear seat cushion cover
  1. using hog ring pliers, install the seat cushion cover with new hog rings.
7. Install separate type rear seat back assy
  1. install the seat back lh with the 2 bolts and 2 clips.

    Torque: 18 nvm (185 kgfvcm, 13 ftvlbf)

  2. employ the same manner described above to the other side.
8. Install bench type rear seat cushion assy
  1. insert the seat cushion under the seat back.
  2. engage the 2 clamps.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.