Toyota Corolla Quiz
Rear suspension

Rear wheel alignment

In this manual: Rear suspension
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
2steps
~12min
1/5difficulty
Done 0 of 2
Inspection 1. Inspect tire 2. Measure vehicle height Notice

: before inspecting the wheel alignment, adjust the vehicle height to the specified value.

 3. Inspect toe–in
Toyota Corolla. Inspect toe–in

Toe–in: usa, canada:

Mexico:

Mexico:

If the toe–in is not within the specified value, inspect and replace

If the toe–in is not within the specified value, inspect and replace the suspension parts as necessary.

4. Inspect camber
  1. install the camber–caster–kingpin gauge or position vehicle on wheel alignment tester.
  2. inspect the camber.

Camber:

If the measured value is not within the specified value, inspect the

If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear and replace them if necessary become camber is not adjustable.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.