Toyota Corolla Quiz
Starting & charging

Replacement

In this manual: Starting & charging
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
4steps
~24min
2/5difficulty
Done 0 of 4
1. Disconnect battery negative terminal 2. Remove engine under cover rh 3. Remove starter assy
Toyota Corolla. Remove starter assy
  1. Disconnect the starter connector.
  2. open the terminal cover.
  3. remove the nut, then disconnect the starter wire.
  4. remove the 2 bolts, then remove the starter.
4. Install starter assy

Torque:
37 nvm (378 Kgf·cm, 27 ft·lbf) for bolt 9.8 Nvm (100 Kgf·cm, 7 ft·lbf) for nut

5. Install engine under cover rh 6. Connect battery negative terminal

torque: 5.4 Nvm (55 Kgf·cm, 48 in.Vlbf)

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.