Toyota Corolla Quiz
Supplemental restraint system

Replacement

In this manual: Supplemental restraint system
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
7steps
~42min
2/5difficulty
Done 0 of 7
Hint

: components:

 1. Precaution 2. Disconnect battery negative terminal 3. Remove horn button assy
Toyota Corolla. Remove horn button assy
  1. Place the front wheels facing straight ahead.
  2. using a torx socket wrench (t30), loosen the 2 torx screws until the groove along the screw circumference catches on the screw case.
    Toyota Corolla. Remove horn button assy
  3. Pull out the horn button assy from the steering wheel assy.
  4. using a screwdriver, release the lock part of each airbag connector and disconnect the 2 airbag connectors.
4. Inspect horn button assy 5. Install horn button assy
  1. connect the airbag connectors and horn connector.
  2. install the horn button assy after confirming that the circumference groove of the torx screws is caught on the screw case.
  3. using a torx socket wrench (t 30), install the 2 screws.

    Torque: 8.8 Nvm (90 kgfvcm, 78 in.Vlbf)

6. Inspect srs warning light

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.