Supplemental restraint system
Replacement
In this manual: Supplemental restraint system
8steps
~48min
2/5difficulty
Done 0 of 8
Hint
: components:
1. Precaution 2. Disconnect battery negative terminal 3. Remove parking brake hole cover sub–assy 4. Remove floor shift shift lever knob sub–assy (m/t transaxle) 5. Remove shifting hole cover sub–assy (m/t transaxle) 6. Remove console panel upper 7. Remove console box carpet 8. Remove rr console box 9. Remove air bag sensor assy center
- Disconnect the 3 connectors from the airbag sensor assy center.
- remove the 3 bolts and airbag sensor assy center.
- check that the ignition switch is turned to off.
- check that the battery negative terminal is disconnected. Notice
: do not start the operation for 90 seconds after removing the terminal.
- temporarily install the airbag sensor assy center with the 3 bolts.
- tighten the 3 bolts to the specified torque.
Torque: 17.5 Nvm (178 kgfvcm, 13 ftvlbf)
- connect the connector to the airbag sensor assy center.
- check that no play is identified.
Test yourself
A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?