Toyota Corolla Quiz
Supplemental restraint system

Replacement

In this manual: Supplemental restraint system
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
7steps
~42min
2/5difficulty
Done 0 of 7
Hint

: components:

 1. Precaution 2. Disconnect battery negative terminal 3. Remove air bag front rh sensor
Toyota Corolla. Remove air bag front rh sensor
  1. Disconnect the connector from the airbag front rh sensor.
  2. remove the 2 bolts and airbag front rh sensor.
4. Inspect air bag front rh sensor 5. Install air bag front rh sensor
  1. check that the ignition switch is turned to off.
  2. check that the battery negative terminal is disconnected. Notice

    : do not start the operation for 90 seconds after removing the terminal.

  3. install the airbag front rh sensor with the 2 bolts.

    Torque: 8.0 Nvm (82 kgfvcm, 71 invlbf)

  4. connect the connector to the airbag front rh sensor.
  5. check that no play is identified.
6. Inspect srs warning light

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.