Toyota Corolla Quiz
Lighting

Replacement

In this manual: Lighting
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
3steps
~18min
2/5difficulty
Done 0 of 3
Hint

: components:

 1. Remove radiator grille sub–assy 2. Remove front bumper cover 3. Remove lh headlamp assy
Toyota Corolla. Remove lh headlamp assy
  1. Remove the 3 bolts.
  2. pull out the headlight assy lh forward, then disconnect the bracket of body side.
    Toyota Corolla. Remove lh headlamp assy
  3. Release the claws and disconnect the connectors as shown in the illustration, and remove the headlight assy lh.
4. Install retainer, headlamp protector, upr lh

Hint: when only the installation part of the headlight assy lh is damaged, it can be repaired inexpensively by using a headlight protector retainer upr lh. In this case, however, the headlight assy lh itself should not be damaged.

Toyota Corolla. Install retainer, headlamp protector, upr lh
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.
Notice

: after cutting off the part roughly, place the headlight protector retainer upr lh against the bosses and gradually file any interfering part until the proper condition for installation is made.
Toyota Corolla. Install retainer, headlamp protector, upr lh
  1. Install the headlight protector retainer upr lh with 2 screws.
5. Install retainer, headlamp protector, lwr lh
Toyota Corolla. Install retainer, headlamp protector, lwr lh
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.
Notice

: after cutting off the part roughly, place the headlight protector retainer lwr lh against the bosses and gradually file any interfering part until the proper condition for installation is made.
Toyota Corolla. Install retainer, headlamp protector, lwr lh
  1. Install the headlight protector retainer lwr lh with a screw.
6. Put vehicle these conditions 7. Adjust fog light aim 8. Headlight aim only

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.