Windshield wiper motor assy

h

1. 1
   operate the wiper and stop the windshield wiper motor assy at the automatic stop position.
2. 2
   remove a nut and fr wiper arm rh.

1. remove a nut and fr wiper arm lh.

1. Using a clipremover, disengage the meshing of 8 clips and remove the hood to cowl top seal.

1. Remove a clip and release the 5 claws, and remove the cowl top ventilator louver rh.

1. Remove a clip and release the 5 claws, and remove the cowl top ventilator louver lh.

1. 1
   Disconnect the connector.
2. 2
   remove the 2 bolts.
3. 3
   slide the wiper link assy to vehicle’s passengers side. Disengage the meshing of the rubber pin and remove the wiper link assy.

1. Using a screwdriver and disengage the meshing of 2 rods at the clank arm pivot of the windshield wiper motor assy.

2. Remove 2 torx bolts and windshield wiper motor assy.

1. 1
   apply mp grease to the clank arm pivot of the windshield wiper motor assy.
2. 2
   using 2 torx bolts, install the windshield wiper motor assy to the windshield wiper link assy.

   Torque: 7.5 Nvm (76 kgfvcm, 66 in.Vlbf)

1. 1
   Install the meshing of the rubber pin.
2. 2
   install the windshield wiper link assy.With the 2 bolts.

   Torque: 5.5 Nvm (56 kgfvcm, 49 in.Vlbf)

3. 3
   connect the connecter.

1. 1
   Operate the wiper, and stop the windshield wiper motor assy at the automatic stop position.
2. 2
   scrape off the serration part of the wiper arm with a round file or equivalent.
3. 3
   clean the wiper pivot serration with the wire brush.

   

4. 4
   Install the front wiper arm lh with a nut at the position as shown in the illustration.

   Torque: 20.5 Nvm (209 kgfvcm, 15 ftvlbf)

1. 1
   Scrape off the serration part of the wiper arm with a round file or equivalent.
2. 2
   clean the wiper pivot serration with the wire brush.
3. 3
   install the front wiper arm rh with a nut to the position shown in the illustration.

Torque: 20.5 Nvm (209 kgfvcm, 15 ftvlbf)

4. operate the wiper while running the water or the washer fluid over the window, and check the wiping condition and that the rear wiper does not hit against the vehicle body.