Toyota Corolla Quiz
Diagnostics

Wiring diagram

In this manual: Diagnostics
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
2steps
~12min
1/5difficulty
Done 0 of 2
1 Inspect terminal voltage(pi) (a) turn
Toyota Corolla. Inspect terminal voltage
  1. Turn the ignition switch to on.
  2. measure voltage between terminal 5 (pi) of cruise control ecu assy and body ground, when the cruise control main switch button is on and off.

    Ok:

    2 Inspect combination meter assy
2 Inspect combination meter assy
3 Check harness and connector(between cruise control ecu assy
3 Check harness and connector(between cruise control ecu assy and combination meter assembly)
  1. Check for open and short circuit in harness and connector between cruise control ecu assy and combination meter assembly
Check and replace cruise control ecu assy
Check and replace cruise control ecu assy

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.