Supplemental restraint system
Airbag sensor front LH
In this manual: Supplemental restraint system
~2min read
COMPONENTS

REPLACEMENT
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
Installation is in the reverse order of removal.
1. PRECAUTION (SEE PAGE 60-1 )
2. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE PAGE 60-1 )
3. REMOVE FRONT BUMPER COVER (SEE PAGE 76-2 )
4. REMOVE RADIATOR GRILLE (SEE PAGE 76-2 )
5. REMOVE LH HEADLAMP ASSY (SEE PAGE 65-10 )
6. REMOVE AIRBAG SENSOR FRONT LH

(a) Disconnect the connector from the airbag sensor front LH.
(b) Remove the 2 bolts and the airbag sensor front LH.
7. INSTALL AIRBAG SENSOR FRONT LH
(a) Check that the ignition switch is off.(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
(c) Install the airbag sensor front LH with the 2 bolts.
Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf)
NOTICE:
- If the airbag sensor front LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the airbag sensor front LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
(e) Check that there is no looseness in the installation parts of the airbag sensor front LH.
8. INSTALL LH HEADLAMP ASSY (SEE PAGE 65-10 )
9. HEADLIGHT AIM ONLY (SEE PAGE 65-14 )
10. CONNECT BATTERY NEGATIVE TERMINAL
11. INSPECT SRS WARNING LIGHT (SEE PAGE 05-1207 )
Was this page helpful?