Ignition

Camshaft position sensor (2AZ-FE)

~1min read

REPLACEMENT

HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).

1. REMOVE AIR CLEANER ASSY (See page 14-24 )

2. REMOVE CAMSHAFT POSITION SENSOR

REMOVE CAMSHAFT POSITION SENSOR

(a) Disconnect the sensor connector.

(b) Remove the bolt and sensor.

3. INSTALL CAMSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to a new O-ring. Install the O-ring onto the sensor.

(b) Install the sensor with the bolt.

Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf)

4. INSTALL AIR CLEANER ASSY (See page 14-24 )