Engine hood/door
Replacement
In this manual: Engine hood/door
~1min read
HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring addition information are included.
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).
1. REMOVE BACK DOOR STAY ASSY LH

(a) Remove the 4 bolts and back door stay from the back door panel.
HINT: While supporting the back door by hand, remove the back door stay.
2. INSTALL BACK DOOR STAY ASSY LH
(a) Install the back door stay with the 4 bolts.
Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf)
Was this page helpful?