Cooling

Thermostat (2AZ-FE)

~1min read

REPLACEMENT

1. DRAIN ENGINE COOLANT (See page 16-6 )

2. REMOVE FAN AND GENERATOR V BELT (See page 14-5 )

3. REMOVE GENERATOR ASSY (See page 19-16 )

4. DISCONNECT RADIATOR HOSE INLET

5. REMOVE WATER INLET

REMOVE WATER INLET

(a) Remove the 2 nuts and disconnect the water inlet from the cylinder block.

6. REMOVE THERMOSTAT

7. INSTALL THERMOSTAT

INSTALL THERMOSTAT

(a) Install a new gasket to the thermostat.

(b) Install the thermostat with the jiggle valve facing up.

HINT: The jiggle valve may be set within 10 on either side of the prescribed position.

8. INSTALL WATER INLET

INSTALL WATER INLET

(a) Install the water inlet with the 2 nuts, as shown in the illustration.

Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf)

9. INSTALL RADIATOR HOSE INLET

10. INSTALL GENERATOR ASSY (See page 19-16 )

11. INSTALL FAN AND GENERATOR V BELT (See page 14-5 )

12. ADD ENGINE COOLANT (See page 16-6 )

13. CHECK FOR ENGINE COOLANT LEAKS (See page 16-1 )