Transfer
Transfer oil (4WD)
In this manual: Transfer
~1min read
ADJUSTMENT
1. REMOVE EXHAUST PIPE ASSY FRONT (3MZ-FE ENGINE TYPE) (SEE PAGE 15-5 )
2. REMOVE EXHAUST PIPE ASSY FRONT (2AZ-FE ENGINE TYPE) (SEE PAGE 15-2 )
3. INSPECT TRANSFER OIL

(a) Remove the No.1 plug and gasket.
(b) Check the oil level is within 0 to 5 mm (0 to 0.1968 in.) down from the lowest end of the hole for No.1 plug.
NOTICE:
- When changing oil, recheck the oil level after driving.
- Excessively large or small quantity of oil may cause some trouble.
(d) Tighten the No.1 plug with a new gasket.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
4. ADD TRANSFER OIL
(a) Remove the No.1 plug and gasket and supply oil.
NOTICE:
- When supplying oil, pour it slowly.
- Repeat supplying oil several times at several minutes interval.
HINT: Within 0 to 5 mm (0 to 0.1968 in.) down from the lowest end of the hole for the No.1 plug.
(b) After leaving it alone for 5 min., check the oil level again.(c) Tighten the No. 1 plug with a new gasket.
5. INSTALL EXHAUST PIPE ASSY FRONT (3MZ-FE ENGINE TYPE) (SEE PAGE 15-5 )
6. INSTALL EXHAUST PIPE ASSY FRONT (2AZ-FE ENGINE TYPE) (SEE PAGE 15-2 )
Was this page helpful?