Check front airbag sensor (vehicle not involved in collision and airbag not deployed)
Perform a diagnostic system check (see page rs- 49).
Check front airbag sensor (vehicle involved in collision and airbag has not deployed)
Perform a diagnostic system check (see page rs- 49).
If the front fender of the vehicle or its periphery are damaged, perform a visual check:
Check for cracks, dents or chips in the case.
Check for cracks, dents, chips and scratches in the connector.
Check for peeling off of the label or damage to the serial number.
If any of the defects mentioned above are present, replace the front airbag sensor with a new one.
Check front airbag sensor (vehicle involved in collision and airbag has deployed)
Replace the front airbag sensor.
Caution:For removal and installation of the front airbag sensor, be sure to follow the correct procedures.Hint:
If the airbags have deployed, replace the front airbag sensor on the side in which the collision occurred. Replace both if necessary.
RemovalCaution:Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
Disconnect cable from negative battery terminal
Caution:Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Remove radiator support opening cover
Remove front airbag sensor lh
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove front airbag sensor rh
Disconnect the sensor connector.
Remove the bolt and sensor.
InstallationCaution:Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
Install front airbag sensor lh
Install the sensor with the bolt.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*Lbf)
Notice:
If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor, make sure that the srs wiring does not interfere with other parts and is not pinched between other parts.
Check that there is no free play in the installation parts of the sensor.
Connect the sensor connector.
Install front airbag sensor rh
Install the sensor with the bolt.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*Lbf)
Notice:
If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor, make sure that the srs wiring does not interfere with other parts and is not pinched between other parts.
check that there is no free play in the installation parts of the sensor.
Connect the sensor connector.
Install radiator support opening cover
Connect cable to negative battery terminal
Check srs warning light
Check the srs warning light (see page rs-34).
?
Test yourself
A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.