Toyota RAV4 Quiz
Sliding roof

Sliding roof switch assembly

In this manual: Sliding roof
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
3steps
~18min
2/5difficulty
Done 0 of 3
Removal
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove map light assembly
Toyota RAV4. Remove map light assembly

  1. Using a clip remover, detach the 4 clips and remove the light.
Hint:

Tape the clip remover tip before use.

  1. Disconnect the map light connector.
Inspection
  1. Inspect map light assembly
Toyota RAV4. Inspect map light assembly

  1. Measure the resistance of the switch.
Standard resistance

If the result is not as specified, replace the map light assembly.

Installation
  1. Install map light assembly
Toyota RAV4. Install map light assembly

  1. Connect the map light connector.
  2. Attach the 4 clips to install the map light.
  3. Connect cable to negative battery terminal

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.