Toyota Sienna Quiz
Brake control

Disassembly

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. REMOVE CYLINDER BOOT

REMOVE CYLINDER BOOT

(a) Using a screwdriver, remove the set ring and cylinder boot.

2. REMOVE REAR DISC BRAKE PISTON

(a) Place a shop rug, between the rear disc brake piston and the disc brake cylinder.

REMOVE REAR DISC BRAKE PISTON

(b) Use compressed air to remove the rear disc brake piston from the disc brake cylinder.

CAUTION: Do not place your fingers in front of the piston when using compressed air.

NOTICE: Do not spatter the brake fluid.

3. REMOVE PISTON SEAL

(a) Using a screwdriver, remove the piston seal from the disc brake cylinder assembly rear LH.

NOTICE: Do not damage the inner cylinder and cylinder groove.

4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

5. REMOVE REAR DISC BRAKE BLEEDER PLUG

(a) Remove the rear disc brake bleeder plug from the disc brake cylinder assembly rear LH.

6. REMOVE REAR DISC

REMOVE REAR DISC

(a) Make matchmarks on the rear disc and the axle hub.

(b) Remove the rear disc.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.