Toyota Sienna Quiz
Engine hood / door

Disassembly

In this manual: Engine hood / door
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
6steps
~36min
2/5difficulty
Done 0 of 6

1. REMOVE BACK DOOR GARNISH CENTER

REMOVE BACK DOOR GARNISH CENTER
  1. Using a clip remover, disengage the 5 clips and remove the garnish center.

2. REMOVE BACK DOOR SIDE GARNISH LH

  1. Using a clip remover, disengage the 3 clips and remove the side garnish.

3. REMOVE BACK DOOR SIDE GARNISH RH

  1. Using a clip remover, disengage the 3 clips and remove the side garnish.

4. REMOVE BACK DOOR PULL STRAP

REMOVE BACK DOOR PULL STRAP
  1. Using a screwdriver, disengage the claws and remove the strap cover.

    HINT: Tape the screwdriver tip before use.

  2. Remove the bolt and strap.

5. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

REMOVE BACK DOOR TRIM BOARD ASSEMBLY
  1. Using the screwdriver, disengage the 14 clips and remove the trim board.

    HINT: Tape the screwdriver tip before use.

  2. Remove the service hole cover from the trim board.

6. REMOVE BACK-UP LIGHT ASSEMBLY LH (See page LI-90)

7. REMOVE BACK-UP LIGHT ASSEMBLY RH (See page LI-90)

8. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE (See page ET-39)

9. REMOVE BACK DOOR LOCK ASSEMBLY

REMOVE BACK DOOR LOCK ASSEMBLY
  1. Disconnect the connector.
  2. Remove the 3 bolts and lock.

10. REMOVE BACK DOOR BASE STOPPER BRACKET

  1. Remove the 4 bolts and 2 stopper brackets.

11. REMOVE BACK DOOR STOPPER LOWER

  1. Remove the 4 bolts and 2 stoppers.

12. REMOVE REAR SPOILER COVER (See page ET-18)

13. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH

14. REMOVE BACK DOOR STAY SUB-ASSEMBLY RH

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.