Toyota Sienna Quiz
U151e automatic transaxle

Dtc clear

In this manual: U151e automatic transaxle
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

(A) when using the obd ii scan tool or intelligent tester: clearing the dtcs.

(1) Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.

(2) Turn the ignition switch to the ON position and turn the OBD II scan tool or the intelligent tester main switch on.

(3) When you use intelligent tester: Select the item "DIAGNOSIS/ENHANCED OBD II/DTC INFO/ CLEAR CODES [YES] button".

HINT: When operating the OBD II scan tool (complying with SAE J1978) or intelligent tester to erase the codes, the DTCs and freeze frame data will be erased. (See the OBD II scan tool's instruction book for operating instructions.) (b) When not using the OBD II scan tool or intelligent tester: Clearing the DTCs.

(1) Disconnect the battery cable or remove the EFI and ETCS fuses from the engine room J/B for 60 seconds or more. However, if you disconnect the battery cable, perform do the "INITIALIZE" procedure.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.