Installation

1. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH

(a) Install the lower ball joint assembly front LH and tighten the nut.

Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf) (b) Install a new cotter pin.

NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.

2. INSTALL FRONT AXLE ASSEMBLY LH

HINT: (See page AH-4)

3. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH

HINT: (See page AH-4)

4. INSTALL TIE ROD ASSEMBLY LH

HINT: (See page AH-4)

5. INSTALL FRONT DISC

6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH

HINT: (See page AH-4)

7. INSTALL SPEED SENSOR FRONT LH

HINT: (See page AH-4)

8. INSTALL FRONT AXLE HUB LH NUT

HINT: (See page AH-4)

9. INSTALL FRONT WHEEL Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (See page SP-4)

11. CHECK ABS SPEED SENSOR SIGNAL

w/o VSC: (See page BC-2).

w/ VSC: (See page BC-68).