Installation

1. INSTALL FRONT STABILIZER BAR

2. INSTALL NO. 1 FRONT STABILIZER BAR BUSHING

(a) Install the 2 front stabilizer bar bush No.1 to the stabilizer bar front.

NOTICE: Install the bushings with the slit facing on the rear side of the vehicle.

HINT: Install the bushing to the outer side of the bushing stopper on the stabilizer bar as shown in the illustration.

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

HINT: (See page EM-48)

4. INSTALL MANIFOLD STAY

HINT: (See page EM-51)

5. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY

HINT: (See page PS-21)

6. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY

HINT: (See page PS-21)

7. CONNECT PRESSURE FEED TUBE ASSEMBLY

HINT: (See page PS-21) SST 09023-12701

8. INSTALL TIE ROD ASSEMBLY LH

HINT: (See page AH-4)

9. INSTALL TIE ROD ASSEMBLY RH

HINT: Remove the RH side by the same procedures as the LH side.

10. INSTALL NO. 1 FRONT STABILIZER BRACKET LH

(a) Install the front stabilizer bracket No.1 LH with the 2 bolts.

Torque: 17 N*m (173 kgf*cm, 12 ft.*lbf)

11. INSTALL NO. 1 FRONT STABILIZER BRACKET RH

HINT: Install the RH side by the same procedures as the LH side.

12. INSTALL CENTER EXHAUST PIPE ASSEMBLY

HINT: (See page EX-10)

13. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

HINT: (See page AH-4)

14. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT: Install the RH side by the same procedures as the LH side.

15. INSTALL FRONT WHEELS

16. INSPECT CENTER FRONT WHEEL

17. INSPECT STEERING WHEEL CENTER POINT

18. ADD POWER STEERING FLUID

19. BLEED POWER STEERING FLUID

HINT: (See page PS-6)

20. CHECK POWER STEERING FLUID LEAKAGE

21. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (See page SP-4)