Toyota Sienna Quiz
Supplemental restraint system

Installation

In this manual: Supplemental restraint system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

  1. Install the curtain shield airbag assembly LH with the 13 bolts in the order shown in the illustration.
INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)

NOTICE: Do not twist the curtain shield airbag assembly LH when installing it.

  1. Install the clip.
  2. Connect the connector to the curtain shield airbag assembly LH.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL POWER BACK DOOR UNIT ASSEMBLY

3. INSTALL ROOF HEADLINING ASSEMBLY

HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (4).

4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

5. INSPECT STEERING WHEEL CENTER POINT

6. INSTALL STEERING PAD

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. PERFORM INITIALIZATION

  1. Perform initialization.

HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.

9. INSPECT SRS WARNING LIGHT

  1. Inspect the SRS warning light

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.