Toyota Sienna Quiz
Exterior

Installation

In this manual: Exterior
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
3steps
~18min
2/5difficulty
Done 0 of 3

1. INSTALL ROOF DRIP SIDE FINISH MOULDING

  1. When exchanging the clips
  2. Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasoline.
  3. Using a heat light, heat up the clip installation surfaces of the vehicle body and moulding.

Heating temperature:

Heating temperature

NOTICE: Do not heat the body and moulding excessively.

Heating temperature
  1. Set the supply clips in the positions as shown in the illustration and press-fit the clips by hand to install them.

NOTICE: Install the moulding when 30 minutes or more have passed after press-fitting the clips.

HINT:

  • Install hardening time: 30 minutes
  • Perfect hardening time: 24 hours
  1. Install the roof drip side finish moulding

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.