Toyota Sienna Quiz
Can communication

Network gateway ECU

In this manual: Can communication
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
4steps
~24min
2/5difficulty
Done 0 of 4

COMPONENTS

COMPONENTS

REMOVAL

1. REMOVE FRONT DOOR SCUFF PLATE LH

2. REMOVE COWL SIDE TRIM BOARD LH

3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH (See page IP-6)

4. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT NO. 1 (See page IP-6)

5. REMOVE CLEARANCE WARNING ECU ASSEMBLY (See page PM-15)

6. REMOVE NETWORK GATEWAY ECU

REMOVE NETWORK GATEWAY ECU
  1. Disconnect each connector.
  2. Remove the nut and network gateway ECU.

INSTALLATION

1. INSTALL NETWORK GATEWAY ECU

INSTALL NETWORK GATEWAY ECU
  1. Install the network gateway ECU with the nut.
  2. Connect the connector.

2. INSTALL CLEARANCE WARNING ECU ASSEMBLY (See page PM-15)

3. INSTALL PANEL SAFETY PAD INSERT NO. 1

4. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH

5. REMOVE COWL SIDE TRIM BOARD LH

6. REMOVE FRONT DOOR SCUFF PLATE LH

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.