Supplemental restraint system
On-vehicle inspection
In this manual: Supplemental restraint system
2steps
~12min
1/5difficulty
Done 0 of 2
1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
- Perform a diagnostic system check.
2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
- Perform a diagnostic system check.
- When the front bumper of the vehicle or its area is damaged, check if there is any damage to the front airbag sensor. If any of the front airbag sensors have defects as mentioned below, replace it with a new one:
- Cracks, dents or chips on the sensor housing.
- Cracks or other damage to the connector.
- Peeling off of the label or damage to the serial number.
CAUTION: Be sure to follow the correct removal and installation procedures.
3. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)
- Replace the front airbag sensor.
CAUTION: Be sure to follow the correct removal and installation procedures.
HINT: The front airbag sensor on the impacted side should be replaced after the steering pad or front passenger airbag assembly has deployed.
Test yourself
A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?