Toyota Sienna Quiz
Windshield / windowglass

Power window regulator motor

In this manual: Windshield / windowglass
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
8steps
~48min
2/5difficulty
Done 0 of 8

INSPECTION

1. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH)

INSPECT POWER WINDOW REGULATOR MOTOR
  1. Remove the power window regulator motor.
  2. Apply battery voltage to the motor connector according to the table below.

NOTICE: Do not apply battery to any terminals except terminals 1 and 2.

Standard

Standard

2. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH)

INSPECT POWER WINDOW REGULATOR MOTOR
  1. Remove the power window regulator motor.
  2. Apply battery voltage to the motor connector according to the table below.

NOTICE: Do not apply battery to any terminals except terminals 1 and 2.

Standard

Standard

3. INSPECT POWER WINDOW REGULATOR NOTOR (REAR RH)

INSPECT POWER WINDOW REGULATOR NOTOR
  1. Remove the power window regulator motor.
  2. Apply battery voltage to the motor connector according to the table below.

NOTICE: Do not apply battery to any terminals except terminals 1 and 2.

Standard

Standard

4. INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)

INSPECT POWER WINDOW REGULATOR MOTOR
  1. Remove the power window regulator motor.
  2. Apply battery voltage to the motor connector according to the table below.

NOTICE: Do not apply battery to any terminals except terminals 1 and 2.

Standard

Standard

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.