Toyota Sienna Quiz
Exterior

Reassembly

In this manual: Exterior
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. INSTALL LH REAR BUMPER SIDE RETAINER

  1. Install the LH rear bumper side retainer with the 3 screws.

2. INSTALL RH REAR BUMPER SIDE RETAINER

  1. Install the RH rear bumper side retainer with the 3 screws.

3. INSTALL REAR BUMPER REINFORCEMENT SUBASSEMBLY

  1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)

4. INSTALL REAR BUMPER BAR PLATE

  1. Install the rear bumper bar plate to the rear bumper reinforcement sub-assembly with the 4 clips.

5. INSTALL REAR BUMPER ENERGY ABSORBER

6. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System) (See page PM-20)

7. INSTALL NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.