Supplemental restraint system

Removal

2steps
~12min
1/5difficulty
Done 0 of 2

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE STEERING WHEEL NO.3 COVER LOWER

  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

HINT: Tape up the screwdriver tip before use.

4. REMOVE STEERING WHEEL NO.2 COVER LOWER

  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

HINT: Tape up the screwdriver tip before use.

5. REMOVE STEERING PAD

  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
    REMOVE STEERING PAD
  2. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

NOTICE: When removing the steering pad, do not pull the airbag wire harness.

  • Disconnect the horn connector.
  • Disconnect the 2 connectors from the steering pad.
  • NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
  • Remove the steering pad.
  • REMOVE STEERING PAD

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.