Toyota Sienna Quiz
Supplemental restraint system

Removal

In this manual: Supplemental restraint system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE REAR DOOR SCUFF PLATE RH

4. REMOVE REAR DOOR WEATHERSTRIP RH

5. REMOVE BACK DOOR WEATHERSTRIP

6. REMOVE BACK DOOR SCUFF PLATE

7. REMOVE LAP BELT OUTER ANCHOR COVER

8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

9. REMOVE AIR DUCT ASSEMBLY

  1. Remove the screw and the air duct assembly.

10. REMOVE REAR AIRBAG SENSOR LH

REMOVE REAR AIRBAG SENSOR LH
  1. Disconnect the connector from the rear airbag sensor LH.
  2. Remove the 2 bolts and the rear airbag sensor LH.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.