Toyota Sienna Quiz
Supplemental restraint system

Removal

In this manual: Supplemental restraint system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

4. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

6. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat)

7. REMOVE VERTICAL ADJUSTING HANDLE NO.2 (for Manual Seat)

8. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)

9. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat)

10. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat)

11. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY

  1. Remove the 5 screws and the front seat cushion shield assembly.

12. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
  1. Remove the seat slide position sensor protector from the seat position sensor.

13. REMOVE SEAT POSITION SENSOR

  1. Disconnect the connector from the seat position sensor.
    REMOVE SEAT POSITION SENSOR
  2. Using a "torx" socket wrench (T30), remove the "torx" screw and the seat position sensor.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.