Toyota Sienna Quiz
Seat belt

Removal

In this manual: Seat belt
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
5steps
~30min
2/5difficulty
Done 0 of 5

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working

2. REMOVE FRONT SEAT ASSEMBLY

HINT:

  • Refer to the instructions for removal of the front seat assembly (for flat type).
  • Refer to the instructions for removal of the front seat assembly (for manual seat).
  • Refer to the instructions for removal of the front seat assembly (for power seat).

3. REMOVE FRONT DOOR SCUFF PLATE

4. REMOVE REAR DOOR SCUFF PLATE

5. REMOVE FRONT DOOR WEATHERSTRIP

6. REMOVE REAR DOOR WEATHERSTRIP

7. REMOVE CENTER PILLAR LOWER GARNISH

8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

NOTICE:

  • Removal operation concerning the seat belt with the pretensioner must be started in 90 seconds or more after the ignition switch is turned OFF and the battery negative terminal is disconnected.
  • Carefully read the notices for the "pretensioner" in the SRS airbag system and the outer belt assembly.
  1. Remove the floor anchor cover.
  2. Remove the bolt and the front seat outer belt assembly on the floor anchor side.
  3. Remove the nut and the front seat outer belt assembly on the shoulder anchor side.
  4. Disconnect the pretensioner connector, as shown in the illustration.
  5. Remove the 2 bolts and front seat outer belt assembly.

9. REMOVE CENTER PILLAR UPPER GARNISH

REMOVE CENTER PILLAR UPPER GARNISH

10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

  1. Remove the bolt and front shoulder belt anchor adjuster assembly.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.