Toyota Sienna Quiz
Navigation

Removal

In this manual: Navigation
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

1. REMOVE INSTRUMENT CLUSTER NO.1 FINISH PANEL CENTER

2. REMOVE INSTRUMENT CLUSTER NO.2 FINISH PANEL CENTER

3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH

4. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
  1. Remove the 4 screws.
  2. Disconnect the connector and remove the navigation receiver assembly with bracket.

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL UPPER

REMOVE INSTRUMENT CLUSTER FINISH PANEL UPPER
  1. Remove the 4 screws and the instrument cluster finish panel upper.

6. REMOVE NO.1 NAVIGATION BRACKET

REMOVE NO.1 NAVIGATION BRACKET
  1. Remove the 4 screws and the No.1 navigation bracket.

7. REMOVE NO.2 NAVIGATION BRACKET

REMOVE NO.2 NAVIGATION BRACKET
  1. Remove the 4 screws and the No.2 navigation bracket from the navigation receiver assembly.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.