Toyota Sienna Quiz
Seat

Removal

In this manual: Seat
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

CAUTION:

  • Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand.
  • Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source. If work is stated within 90 seconds from disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

HINT: Use the same procedures for the RH side and LH side.

1. REMOVE FRONT SEAT HEADREST ASSEMBLY

2. REMOVE FRONT SEAT ASSEMBLY LH

REMOVE FRONT SEAT ASSEMBLY LH
  1. Using a screwdriver, pry out the 2 seat track covers.

HINT: Tape the screwdriver tip before use.

  • Disconnect the connectors under the seat assembly.
  • Remove the 4 bolts and the seat assembly.

    • NOTICE: Be careful not to damage the body.

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.