Toyota Sienna Quiz
Engine

Replacement

In this manual: Engine
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read
5special tools

1. REPLACE GENERATOR DRIVE END FRAME BEARING

REPLACE GENERATOR DRIVE END FRAME BEARING

(a) Remove the 4 screws and retainer plate from the drive end frame.

REPLACE GENERATOR DRIVE END FRAME BEARING

(b) Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.

SST 09950-60010 (09951-00250), 09950-70010 (09951-07100)

REPLACE GENERATOR DRIVE END FRAME BEARING

(c) Using SST and a press, press in a new generator drive end frame bearing.

SST 09950-60010 (09951-00470), 09950-70010 (09951-07100)

REPLACE GENERATOR DRIVE END FRAME BEARING

(d) Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.

(e) Install the 4 screws.

Torque: 2.3 N*m (23 kgf*cm, 20 in.*lbf)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.