Toyota Sienna Quiz
Cruise control

Road test

In this manual: Cruise control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
28steps
~168min
4/5difficulty
Done 0 of 28

1. PROBLEM SYMPTOM CONFIRMATION

PROBLEM SYMPTOM CONFIRMATION
  1. Inspect the SET function.
  2. Turn the cruise control main switch on.
  3. Drive at the required speed between 40 km/h and 200 km/h.
  4. Push the cruise control main switch to - (COAST)/SET.
  5. After releasing the switch, check that the vehicle cruises at the set speed.
    PROBLEM SYMPTOM CONFIRMATION
  6. Inspect the + (ACCEL) function.
  7. Turn the cruise control main switch on.
  8. Drive at the required speed between 40 km/h and 200 km/h.
  9. Push the cruise control main switch to - (COAST)/SET.
  10. Check that vehicle speed increases while the cruise control main switch is pushed to + (ACCEL)/RES (RESUME), and that the vehicle cruises at the newly set speed when the switch is released.
  11. Push the cruise control main switch to + (ACCEL)/RES (RESUME) and then release it immediately. Check that vehicle speed increases by approximately 1,6 km/h (tap-up control).
    PROBLEM SYMPTOM CONFIRMATION
  12. Inspect the - (COAST) function.
  13. Turn the cruise control main switch on.
  14. Drive at the required speed between 40 km/h and 200 km/h.
  15. Push the cruise control main switch to - (COAST)/SET.
  16. Check that vehicle speed decreases while the cruise control main switch is pushed to - (COAST)/SET, and that the vehicle cruises at the newly set speed when the switch is released.
  17. Push the cruise control main switch to - (COAST)/SET, and then release it immediately.

    Check that vehicle speed decreases by approximately 1,6 km/h (tap-down control).

    PROBLEM SYMPTOM CONFIRMATION
  18. Inspect the CANCEL function.
  19. Turn the cruise control main switch on.
  20. Drive at the required speed between 40 km/h and 200 km/h.
  21. Push the cruise control main switch to - (COAST)/SET.
  22. When performing any one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.
  • Depressing the brake pedal
  • Moving the shift lever from the D or 4 to the N, 3, 2 or L position
  • Turning the cruise control main switch off
  • Pulling the cruise control main switch to CANCEL
PROBLEM SYMPTOM CONFIRMATION
  1. Inspect the RES (RESUME) function.
  2. Turn the cruise control main switch on.
  3. Drive at the required speed between 40 km/h and 200 km/h.
  4. Push the cruise control main switch to - (COAST)/SET.
  5. Cancel the cruise control system by performing any of the above operations (other than turning the main switch off).
  6. After pushing the cruise control main switch to + (ACCEL)/RES (RESUME) at a driving speed of more than 40 km/h, check that the vehicle resumes the speed set prior to the cancellation.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.