Toyota Sienna Quiz
Transfer

Transfer oil

In this manual: Transfer
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

ON-VEHICLE INSPECTION

1. INSPECT TRANSFER OIL

INSPECT TRANSFER OIL

(a) Remove the No. 1 plug and gasket.

(b) Check the oil level is within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for No. 1 plug.

NOTICE:

  • When changing oil, recheck the oil level after driving.
  • Excessively large or small quantity of oil may cause some trouble.

(c) When the oil level is too low, check for oil leakage.

(d) Tighten the No. 1 plug with a new gasket.

Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)

2. ADD TRANSFER OIL

(a) Remove the No. 1 plug and gasket and supply oil.

NOTICE:

  • When supplying oil, pour it slowly.
  • Supply oil several times at several minutes interval.

HINT: The oil level should be within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for the No. 1 plug.

(b) After leaving it alone for 5 minutes, recheck the oil level.

(c) Tighten the No. 5 plug with a new gasket.

Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.