Turn signal lever

Operating instructions

1. 1
   Right turn
2. 2
   Left turn
3. 3
   Lane change to the right (move the lever partway and release it) The right hand signals will flash 3 times.
4. 4
   Lane change to the left (move the lever partway and release it) The left hand signals will flash 3 times.

Turn signals can be operated when

The engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system).

If the indicator flashes faster than usual

Check that a light bulb in the front or rear turn signal lights has not burned out.

If the turn signals stop flashing before a lane change has been performed

Operate the lever again.

To discontinue flashing of the turn signals during a lane change

Operate the lever in the opposite direction.