Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for both the LH and RH sides.
• The procedure described below is for the LH side.

PROCEDURE

1. REMOVE OUTER MIRROR

(a) Push the lower part of the mirror surface and tilt it.

Text in Illustration

	Protective Tape
	Push

(b) Apply protective tape to the area shown in the illustration.

(c) Push the upper part of the mirror surface and tilt it.

Text in Illustration

	Protective Tape
	Push

(d) Apply protective tape to the area shown in the illustration.

(e) Using a moulding remover D, disengage the 2 claws on the lower part of the outer mirror.

(f) Push the lower part of the mirror surface.

HINT:

If excessive force is used when pressing down the mirror surface, the 2 claws will engage again.

(g) Using a moulding remover D, disengage the 2 claws on the upper part of the outer mirror.

(h) Remove the protective tape.

(i) Disengage the clamp.

(j) Disconnect the 3 connectors to remove the outer mirror.

NOTICE:

• Do not bend the tabs excessively to prevent them from being damaged.
• If the tabs are damaged, replace the outer mirror with a new one.
• If the wire harness is damaged or any of the wires are broken, replace the outer rear view mirror assembly with a new one.

2. REMOVE OUTER MIRROR COVER (w/o Side Turn Signal Light)

(a) Disengage the 8 claws to remove the outer mirror cover.

3. REMOVE OUTER MIRROR COVER (w/ Side Turn Signal Light)

(a) Disengage the 7 claws to remove the outer mirror cover.

4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (w/ Side Turn Signal Light)