Inspection
1. INSPECT REAR NO. 2 POWER WINDOW REGULATOR SWITCH ASSEMBLY
*a |
Component without harness connected (Rear No. 2 Power Window Regulator Switch Assembly) |
*b |
Pull (Close) |
*c |
Push (Open) |
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
|
|---|---|---|---|
6 (UP) - 2 (E) |
Pull (Close) |
Pulled |
Below 1 Ω |
Not pulled |
10 kΩ or higher |
||
4 (DOWN) - 2 (E) |
Push (Open) |
Pushed |
Below 1 Ω |
Not pushed |
10 kΩ or higher |
||
If the result is not as specified, replace the rear No. 2 power window regulator switch assembly.
(b) Check that the LED illuminates.
(1) Apply battery voltage to the rear No. 2 power window regulator switch assembly.
OK:
Measurement Condition | Specified Condition |
|---|---|
Battery positive (+) → 8 (ILL+) Battery negative (-) → 1 (ILL-) |
LED illuminates |
If the result is not as specified, replace the rear No. 2 power window regulator switch assembly.
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.