Toyota Tacoma Quiz
Can Communication

Network Gateway Ecu

In this manual: Can Communication
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
0102030405032N·mlb·ft
Tightening torque found on this page
Components COMPONENTS ILLUSTRATION Installation Installation INSTALLATION PROCEDURE

1. INSTALL NETWORK GATEWAY ECU

(a) Install the network gateway ECU with the bolt.

Torque:

3 N·m {31 kgf·cm, 27 in·lbf}

(b) Connect the connector.

2. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY

(See page Removal Removal )

Removal REMOVAL PROCEDURE

1. REMOVE LOWER INSTRUMENT PANEL ASSEMBLY

(See page 2. REMOVE NETWORK GATEWAY ECU 2. REMOVE NETWORK GATEWAY ECU )

2. REMOVE NETWORK GATEWAY ECU

(a) Disconnect the connector.

(b) Remove the bolt and network gateway ECU.

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.