Supplemental Restraint Systems

On-vehicle Inspection

~1min read
ON-VEHICLE INSPECTION PROCEDURE

1. INSPECT FRONT SEAT AIRBAG ASSEMBLY LH (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check (See page ).

(b) With the front seat airbag assembly LH installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat with a new one:

Cuts, minute cracks or marked discoloration on the front seatback around the front seat airbag assembly LH.

2. INSPECT FRONT SEAT AIRBAG ASSEMBLY LH (for Vehicle Involved in Collision and Airbag has not Deployed)

(a) Perform a diagnostic system check (See page ).

(b) With the front seat airbag assembly LH removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat airbag assembly LH with a new one:

  • Cuts, minute cracks or marked discoloration on the front seat airbag assembly LH.
  • Cracks or other damage to the wire harness or connector.

    CAUTION:

    For removal and installation procedures of the front seat airbag assembly LH, be sure to follow the correct procedure.

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.