Pre-collision System Warning Buzzer

1. INSPECT SKID CONTROL BUZZER

(a) Make sure that there is no looseness in the locking part and connecting part of the connector.

(b) Disconnect the skid control buzzer connector.

(c) Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.

(d) Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the skid control buzzer, and check that the buzzer sounds.

OK:

The skid control buzzer sounds.

If the result is not as specified, replace the skid control buzzer.

1. REMOVE SKID CONTROL BUZZER

(a) Disengage the clamp.

(b) Disconnect the connector to remove the skid control buzzer.

NOTICE:

If the skid control buzzer has been struck or dropped, replace it with a new one.

1. INSTALL SKID CONTROL BUZZER

(a) Connect the connector.

(b) Engage the clamp to install the skid control buzzer.

NOTICE:

If the skid control buzzer has been struck or dropped, replace it with a new one.

HINT:

Make sure to install the skid control buzzer in the correct direction.