Engine, Hybrid System
Inspection
INSPECTION
PROCEDURE
1. INSPECT CRUISE CONTROL MAIN SWITCH
(a) w/o Dynamic Radar Cruise Control System:
(1) Measure the resistance according to the value(s) in the table below. Text in Illustration
*a |
Component without harness connected
(Cruise Control Main Switch Assembly) |
- |
- |
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
1 (ECC) - 3 (CCS) |
Neutral |
10 MΩ or higher |
+RES |
236 to 244 Ω |
-SET |
618 to 642 Ω |
CANCEL |
1510 to 1570 Ω |
Main Switch ON |
Below 1.5 Ω |
Main Switch OFF |
10 MΩ or higher |
If the result is not as specified, replace the cruise control main switch.
(b) w/ Dynamic Radar Cruise Control System:
(1) Measure the resistance according to the value(s) in the table below.
*a |
Component without harness connected
(Cruise Control Main Switch Assembly) |
- |
- |
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
1 (ECC) - 3 (CCS) |
Neutral |
10 MΩ or higher |
+RES |
236 to 244 Ω |
-SET |
618 to 642 Ω |
CANCEL |
1510 to 1570 Ω |
Main Switch ON |
Below 1.5 Ω |
If the result is not as specified, replace the cruise control main switch assembly. |
Was this page helpful?