(a) If there are any defects as mentioned below, replace the spiral cable sub-assembly with a new one:
Scratches, cracks, dents or chips on the connector or the spiral cable sub-assembly.
(b) Check the spiral cable sub-assembly.
(1) Set the spiral cable sub-assembly to the center position (see page ).
(2) After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown. Then rotate the spiral cable sub-assembly 5 times counterclockwise, measure the resistance according to the U4 (uecs) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
J11-1 - I1-2
Always
Below 1 Ω
J11-2 - I1-1
J11-3 - I2-1
J11-4 - I2-2
J45-6 - A-10
J45-5 - A-9
J45-4 - A-8
J45-3 - A-7
J45-2 - A-6
J45-2 - P14-4
J45-1 - P14-3
J45-12 - A-5
J45-11 - A-4
J45-10 - A-3
J45-9 - A-2
J45-8 - A-1
J45-8 - P14-2
J45-7 - P14-1
(3) After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable 5 times counterclockwise, measure the resistance according to the U4 (uecs) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
J11-1 - I1-2
Always
Below 1 Ω
J11-2 - I1-1
J11-3 - I2-1
J11-4 - I2-2
J45-6 - A-10
J45-5 - A-9
J45-4 - A-8
J45-3 - A-7
J45-2 - A-6
J45-2 - P14-4
J45-1 - P14-3
J45-12 - A-5
J45-11 - A-4
J45-10 - A-3
J45-9 - A-2
J45-8 - A-1
J45-8 - P14-2
J45-7 - P14-1
NOTICE:
As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.